The Yankee Ps-M2 (230V) is a professional power supply able to deliver both DC and AC power to your effects pedals. It has five fully isolated sections with up to 17 outputs. Includes a LED USB lamp and cables.
Security policy (edit with module Customer reassurance)
Delivery policy (edit with module Customer reassurance)
Return policy (edit with module Customer reassurance)
Section I - 5 outputs, 9V DC, 1200 mA
Section II - 5 outputs, 9V DC, 1200 mA
Section III - 2 outputs SAG with variable DC voltage 1V - 10V, 600mA (Low battery simulation)
Section IV - 2 outputs with individual voltage regulation (6VDC, 9VDC, 12VDC, 15VDC, 18VDC and 24VDC), 600 mA
Section V - 3 outputs 9VAC + 12VAC + 14VAC, 2000mA
This power supply can feed virtually every effect pedal on the market
Ability to change the location of the power cable slot (up or back). This allows even greater opportunity to match settings for a specific pedalboard. Two options position can be seen in the pictures.
It has very good quality secondary voltage and significantly less distortion. When you use the AC adapter no hum is heard.
It provides stable voltage independent of mains voltage fluctuations.
Effective filter Voltage:
Very effective filter allows you to power even the most sensitive guitar effects. Short-circuit protection
Disconnects the output of which is shorted. This is important because of the special nature of these services results. They are likely to + out and it happens, for example. During a concert that upon contact with the metal casing of the effect of a short circuit. In this case, disconnect the power supply to the output will not be burnt and turn on cessation of the circuit.
Protection against overheating:
The power supply was used high-current limiting circuit, overheating of the heat sink.
USB out and LED lamp
Input voltage: 230V / 50Hz
Dimensions: 52mm x 140mm x 105mm (H x W x L)